This is a single shift not a zero shift. Slide 2 shows the address with the shaft on the elbow plane and when you go to slide 3 the shaft shifts to the turned shoulder plane. Please if you get a chance change slide 2 and have the stick man not bent over from the waist as much and put the shaft on the turned shoulder plane. Then you will have a zero shift. I use this pattern for the Hammer Swing and would like to make an animated gif of the stick man if that is ok. Thanks John W Rohan-Weaver G.S.E.M.
Last edited by purehitter : 08-04-2008 at 01:51 AM.
Threaded Mode
