LynnBlakeGolf Forums - View Single Post - Clubhead Speed
Thread: Clubhead Speed
View Single Post
  #5  
Old 11-03-2007, 08:58 AM
bts's Avatar
bts bts is offline
Senior Member
 
Join Date: Jan 2005
Location: Taipei, Taiwan
Posts: 352
Clubhead speed at separation and ball reformation
Originally Posted by lagster View Post
I have heard that the minimum tour level clubhead speed is somewhere around 107, or so with a driver. If anyone has the exact number, that would be good. Most people have lower than that, and there are the few that have speeds on up there. I think Fred Couples is around 113, and John Daly is around 130 m.p.h..

How about a discussion of the various ways of increasing CLUBHEAD SPEED, and thus, DISTANCE. I'll start.

1. A longer club... This will sometimes work, if the player can handle the longer, and often heavier club. Wedgy Winchester, won one of the Long Drive Competitions with a very long club, howerer, I don't see many good players using the very long clubs.
For clubhead speed:

1. A longer club can help, only if more power can be supplied. Otherwise, the rpm slows down.
2. Faster pivot rotation
3. Faster and more active arms pulling in "swinging" or pushing in "hitting".
3. More passive wrists in "swinging" and active wrists in "hitting".
4. Harder snapping.

For distance:

1. Higher clubhead speed at impact to deform the ball more.
2. Higher clubhead speed at separation by resisting against ball reformation (or "impact deceleration") or "sustaining the line of compression" with higher clubhead acceleration rate (at impact).
__________________
Yani Tseng, Go! Go! Go!
Yani Tseng Did It Again!
YOU load and sustain the "LAG", during which the "LAW" releases it, ideally beyond impact.
"Sustain (Yang/陽) the lag (Yin/陰)" is "the unification of Ying and Yang" (陰陽合一).
The "LAW" creates the "effect", which is the "motion" or "feel", with the "cause", which is the "intent" or "command".
"Lag" is the secret of golf, passion is the secret of life.
Think as a golfer, execute like a robot.
Rotate, twist, spin, turn.
Bend the shaft.
Reply With Quote