*Reference is made to TGM and to results from the Motion Analysis Technology by TaylorMade System in linking a level shoulder turn and a “drawing” type ball flight pattern.
*The transitional motion into the downswing will be easier and more consistent if the shoulders are allowed to turn perpendicular to the axis of the spine in route to the top.
*The rear shoulder can ride high into the backswing or tilt because the level shoulder turn requires some flexibility of the upper torso and an “astute” lower body control in the move to the top
*Three moves will make the level shoulder turn more “accessible.”
1-Lateral spinal tilt at address of 2 to 4 inches.
2-Holding the flex and position of the right knee established at address all the way to the top. The hips will make a level turn and influence the shoulders
3 -The spine leaning away from the target and over the right leg at the top.
Mirror work while swinging a heavy club is recommended. He cautions that #1 can be overdone but starting without sufficient #1 can produce a “sway” or excessive head movement. A slide or straightening of the right knee results in the spine, left shoulder and head falling forward.
FWIW, for me, note was made of the flexibility demands for this motion but also the importance of monitoring the right shoulder when making the flatter turn of 10-13-B. And, the article stimulated a study of 7-16.
Hybrid Mode
