[12 piece bucket]

Bagger hollering from the wiring closet.

What happens to the paddlewheel when you hit the corner and when should you pull the trigger?

Read the second paragraphs of 7-18 and 7-20 as they relate to small pulleys...

7-18 . . .

Then understanding and executing the Left Wrist Action per 2-N-1, synchronizes the entire procedure. Trigger Delay alters little geometrical but magnifies the physics. The Paddlewheel Action of the straightening Right Elbow (10-10-C) initiates and sustains the #3 Accumulator Hand Motion (4-D-0) unit the Both-Arms-Straight and Zero Accumulator #3 position of Full Extension – but, of course, under the guidance of the Flat, Vertical Left Wrist Hinge Action (2-G). Accumulator #3 Action is not Lever Assembly Extension. See 2-P. With the Endless Belt Effect, The Belt (Hands) and the Clubhead have the RPM but the Surface factor sets in and gives the Clubhead greater MPH – in reverse proportion to the size of the Pulley (the smaller, the faster). That is, raised Hand Position – reducing the Accumulator #3 Travel –plus Trigger Delay. Conversely – a larger Pulley (lowered Hands) requires a higher Handspeed and an earlier Trigger. See 6-B-3-A, 6-F and 6-N-0.

smoothly, steadily with no change in the straightening or the Paddlewheel rate of Clubface Closing as set up AT RELEASE. Variations in Trigger Delay are possible ONLY beacuse the Cocked Left Wrist allows the Right Elbow to straighten faster than the Left Arm would otherwise allow (6-B-1) and the greater the Delay the more rapid the Paddlewheel Action and the more Swivel-like it becomes without increasing the actual Endless Belt speed of the Left Hand."

7-20 . . .

The term “Trigger” is used to denote that action which initiates the Release of the Power Package Assembly of Power Accumulators (6-B) to develop and apply force to the ball. It is the lengthening of the third side of the Triangle Assembly which moves the Lever Assemblies toward and through Impact per Pattern. See 6-M-0.

The procedures are termed “Throws” wither they “throw” or are “thrown.” They may be used individually or in combinations. The standard combinations are listed only in Chapter 11-20. Trigger Types are selected according to Release Type and Release Point as defined in 10-20 and 10-24 – that is, Sweep with Sweep, Snap with Snap, etc. For Hitters that means that Triggering (7-20), Assembly (7-21), Loading (7-22), Delivery (7-23) and Release (7-24) require an active Right Elbow and an inactive Left Wrist. For Swingers – vice versa. Study 6-C-2-A, 7-3 and 10-3-K. Remember – an “Active Right Arm” can be Monitored ONLY through awareness of an “Active Right Elbow.” Study 2-G regarding the Swivel and Rhythm. Maximum Trigger Delay noticeably restricts maximum Handspeed (6-N-0). Every Player has a maximum Handspeed and no amount of violent effort will change it much. However, that violent effort per 7-19, cause the Clubhead to fly out into its own orbit prematurely with typical Throwaway results.
WITH THE FLAT LEFT WRIST IN LINE WITH THE RIGHT FOREARM (7-2-3) THE #3 ACCUMULATOR "CLOSES" ONLY AS THE STRAIGHTENING RIGHT ELBOW - ACTIVE OR PASSIVE - PROVIDES THE BASIC PADDLEWHEEL MOTION FOR THE LEFT ARM FLYING WEDGE (6-B-3-0-1) AND FOR THE HAND MOTION PER 4-D-0. THIS IS THE TRUE "OVERTAKING" ACTION (6-F) OF THE LAGGING CLUBHEAD AS DIFFERENTIATED FROM LEVER ASSEMBLY EXTENSION IN 2-P. SO WITH DOWNSTROKE WAGGLES, VERIFY - THROUGH THE HANDS ONLY - THAT THE RIGHT ELBOW WILL BE ON PLANE BEFORE TRIGGERING TO ASSURE ACCURATE TRACING (5-0) FOR THE FOLLOW-THROUGH. ESPECIALLY WITH DELAYED RELEASE THIS WILL ROTATE THE LEFT HAND IN A SWIVELLING ACTION AS REQUIRED FOR RHYTHM (2-C-0, 2-G, 6-J-O).

Let me read on these a lil' bit and I'll holla back.

Another thought on your first question though . . . as a general rule more #3 Angle requires GREATER handspeed.